Quanta Computer QuantaMesh User Manual page 815

UANTA COMPUTER INC.
6.11.2.32 default-information originate
This command is used to control the redistribution of a protocol or network into the BGP, use the
default-information originate command in address family or router configuration mode. To disable this
function, use the no form of this command.
Syntax
default-information originate <always>
no default-information originate
<always>: Originate a default route even if routing table doesn't have one.
Default Setting
Disabled
Command Mode
Router BGP Config Mode
6.11.2.33 maximum-paths
This command is used to configure the maximum number of parallel routes that an IP routing protocol
will install into the routing table, use the maximum-paths command in router bgp configuration. To
restore the default value, use the no form of this command.
Syntax
maximum-paths [ibgp] <number>
no maximum-paths [ibgp] <number>
<number>: Specifies the number of routes to install to the routing table. The range is from 1 to 32.
Default Setting
None
Command Mode
Router BGP Config Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 815