Quanta Computer QuantaMesh User Manual page 870

UANTA COMPUTER INC.
7.5.2.12 ip pim join-prune-interval
This command is used to configure the join/prune interval for the PIM-SM router on an interface or range
of interfaces. The join/prune interval is specified in seconds. This parameter can be configured to a value
from 0 to 18000.
Syntax
ip pim join-prune-interval <0-18000>
no ip pim join-prune-interval
no - Use this command to set the join/prune interval to the default value.
Default Setting
60
Command Mode
Interface Config
This command takes effect only when PIM-SM is configured as the PIM mode
i
7.5.2.13 ip pim-trapflags
This command enables the PIM trap mode for both Sparse Mode (SM) and Dense Mode. (DM).
Syntax
ip pim-trapflags
no ip pim-trapflags
no - This command sets the PIM trap mode to the default
Default Setting
Disabled
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands 870