Quanta Computer QuantaMesh User Manual page 813

UANTA COMPUTER INC.
6.11.2.29 neighbor send-community
This command is used to specify that communities attribute should be sent to a BGP neighbor, use the
neighbor send-community command in router configuration mode. To remove the entry, use the no form
of this command.
Syntax
neighbor <peeripaddr> send-community
no neighbor <peeripaddr> send-community
peeripaddr: IP address of the neighboring router.
Default Setting
None
Command Mode
Router BGP Config Mode
6.11.2.30 distance
This command is used to set the distance based on source and destination information obtained from
the routes. To return to the default values, use the no form of this command.
Syntax
distance <1-255> <ipv4-prefix> <wildcard-mask> [prefix-list]
no distance
Default Setting
None
Command Mode
Router BGP Config Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 813