Email Alerting And Mail Server Commands; Show Commands - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

5.6 Email Alerting and Mail Server Commands

Email Alert is an extension of the logging system. This feature can immediately send urgent log
messages to a specified mail address by email. It also can send non-urgent log messages created in a
specified interval to a specified address. If there is no buffer to keep non-urgent log messages in the
specified interval, the log messages will be sent and cleared.

5.6.1 Show Commands

5.6.1.1 Show logging email config
This command displays information about the email alert configuration.
Syntax
show logging email config
Default Setting
None
Command Mode
Privileged Exec
Display Message
Email Alert Logging The administrative status of the feature: enabled or disabled.
Email Alert Form Address The email address of the sender (the switch).
Email Alert Urgent Severity Level The lowest severity level that considered urgent. Messages of
this type are sent immediately.
Email Alert Non Urgent Severity Level The lowest severity level that is considered non-urgent.
Messages of this type, up to the urgent level, are collected and sent in a batch email. Log messages
that are less severe are not sent in an email message at all.
Email Alert Trap Severity Level The lowest severity level at which traps are logged.
Email Alert Notification Period The amount of time to wait between non-urgent messages.
Email Alert To Address Table The configured email recipients.
Email Alert Subject Table The subject lines included in urgent and non-urgent messages.
For Msg Type urgent, subject is The configured email subject for sending urgent messages.
For Msg Type non-urgent, subject is The configured email subject for sending non-urgent
messages.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 311