Expandable Port Configuration - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

5.2.16 Expandable Port Configuration

Expandable ports allow the administrator to configure a 40G port in either 4x10G mode or 1x40G mode.
When the 40G port is operating in 4x10G mode, the port operates as four 10G ports, each on a separate
lane. This mode requires the use of a suitable 4x10G to 1x40G pigtail cable. The mode of the
expandable port takes place when the system boots, so if the mode is changed during the switch
operation, the change does not take effect until the next boot cycle.
5.2.16.1 show interface port-mode
Use this command to display the hardware information for the 40G ports. The command displays the
40G interface and the corresponding 10G interfaces. A change on the configuration will be effective with
the next boot of the switch.
Syntax
show interface port-mode [<slot/port>]
<slot/port> - Specify an 40G interface to display.
Command Mode
Privileged EXEC
Display Message
40G Interface: Indicates the interface number of 40G port.
10G Interfaces: Indicates the interface number of 10G ports.
Configured Mode: Indicates the configured mode of the 40G port. The mode should be 1x40G or
4x10G.
Oper Mode: Indicates the current operational mode of the 40G port. The mode should be 1x40G or
4x10G.
40G Interface 10G Interfaces
------------- --------------
0/49 0/53-56
0/50 0/57-60
0/51 0/61-64
0/52 0/65-68
Configured Oper
Mode Mode
---------- -------
4x10g 4x10g
1x40g 1x40g
1x40g 1x40g
1x40g 1x40g
QuantaMesh | Switching Commands
Layer 2/3/4 Managed Switch
195