Show Dcb Fip-Snooping Vlan; Fip-Snooping - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

9.1.5 show dcb fip-snooping vlan

This command displays FIP snooping whether enable or disable on specific VLAN.
Syntax
show dcb fip-snooping vlan {< 1-4093> | all}
<1 - 4093> - VLAN ID.
all - This command represents all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Vlan ID: fip-snooping function status on the specific VLAN.

9.1.6 fip-snooping

The FIP snooping function is disabled by default. Only after enabling it, are the FIP related CLIs under
VLAN and interface mode visible. The FIP-snoop process also starts after the "fip-snooping" command
is enabled. Once the feature is enabled, the FIP-snoop packets and FCoE packets are dropped, unless
explicitly enabled on a per-VLAN basis. If FIP snooping is enabled, all the FIP frames are snooped and
security ACLs are added. FCoE traffic is blocked on all ports until the device re-initializes with FIP. If the
feature is disabled, snooping is removed and all programmed ACLs and internal data are cleaned up.
Syntax
fip-snooping
no fip-snooping
no - This command disables fip snooping function.
Default Setting
Disabled
Command Mode
DCB (Data Center Bridging) Config
QuantaMesh | Data Center Bridging Commands
Layer 2/3/4 Managed Switch
989