Quanta Computer QuantaMesh User Manual page 66

UANTA COMPUTER INC.
5.2.1.9 capabilities
This command is used to set the capabilities on specific interface.
The 10-Giga and 40-Giga interfaces do not provide the following command.
i
Syntax
capabilities {{10 | 100 } {full-duplex | half-duplex}} | {1000 full-duplex }
no capabilities {{10 | 100 } {full-duplex | half-duplex}} | {1000 full-duplex }
10 - 10BASE-T
100 - 100BASE-T
1000 - 1000BASE-T
full-duplex - Full duplex
half-duplex - Half duplex
no - This command removes the advertised capability with using parameter.
Default Setting
10G full-duplex for 10G ports
40G full-duplex for 40G ports
Command Mode
Interface Config
This command is used to set the capabilities on all interfaces.
Syntax
capabilities all {{10 | 100} {full-duplex | half-duplex}} | {1000 full-duplex }
no capabilities all {{10 | 100} {full-duplex | half-duplex}} | {1000 full-duplex }
10 - 10BASE-T
100 - 100BASE-T
1000 - 1000BASE-T
full-duplex - Full duplex
half-duplex - Half duplex
all - This command represents all interfaces.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 66