Configuration Commands - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.
MTU size: Shows the maximum transmission size for packets on this interface, in bytes.

8.2.2 Configuration Commands

8.2.2.1 interface loopback
This command uses to enter the Interface Config mode for a loopback interface. The range of
the loopback ID is 0 to 7.
Syntax
interface loopback <0-7>
no interface loopback <0-7>
no - This command removes the loopback interface and associated configuration parameters for the
specified loopback interface.
Default Setting
Disabled
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands 903