Quanta Computer QuantaMesh User Manual page 883

UANTA COMPUTER INC.
mask for the group address. The optional keyword override indicates that if there is a conflict, the RP
configured with this command prevails over the RP learned by BSR.
Syntax
ipv6 pim rp-address <rp-address> <group-address/prefix-length> [override]
no ipv6 pim rp-address <rp-address> <group-address/prefix-length>
<rp-address> - The IPv6 address of the RP.
<group-address> - The group address supported by the RP.
<prefix-length> - The group mask for the group address.
override - Indicates that if there is a conflict, the RP configured with this command prevails over the
RP learned by BSR.
no - This command is used to remove the address of the configured PIM Rendezvous point (RP) for
the specified multicast group range.
Default Setting
None
Command Mode
Global Config
7.6.2.10 ipv6 pim rp-candidate
This command is used to configure the router to advertise itself as a PIM candidate rendezvous point
(RP) to the bootstrap router (BSR) for a specific multicast group range.
Syntax
ipv6 pim rp-candidate interface {<slot/port> | vlan <vlan-id>} <group-address/prefix-length> [interval
<interval>]
no ipv6 pim rp-candidate interface {<slot/port> | vlan <vlan-id>} <group-address/prefix-length>
<slot/port> - The IP address associated with this interface type and number is advertised as a
candidate RP address. This interface must be enabled with PIM.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.<group-address> - The multicast group
address that is advertised in association with the RP address.
<prefix-length> - The multicast group prefix that is advertised in association with the RP address.
<interval> - Configure the C-RP advertisement interval. The range of interval is 1 to 16383, and the
default value is 60.
no - This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands 883