UANTA COMPUTER INC.
6.3.1.7 show ip ospf interface
This command displays the information for the IFO object or virtual interface tables.
Syntax
show ip ospf interface {<slot/port> | loopback <loopback-id> | vlan <vlan-id>}
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
IP Address: The IP address for the specified interface.
Subnet Mask: A mask of the network and host portion of the IP address for the OSPF interface.
Secondary IP Address(es): The secondary IP addresses if any are configured on the interface.
OSPF Admin Mode: States whether OSPF is enabled or disabled on a router interface.
OSPF Area ID: The OSPF Area ID for the specified interface.
OSPF Network Type: The type of network on this interface that the OSPF is running on.
Router Priority: A number representing the OSPF Priority for the specified interface.
Retransmit Interval: A number representing the OSPF Retransmit Interval for the specified
interface.
Hello Interval: A number representing the OSPF Hello Interval for the specified interface.
Dead Interval: A number representing the OSPF Dead Interval for the specified interface.
LSA Ack Interval: A number representing the OSPF LSA Acknowledgment Interval for the specified
interface.
Transit Delay Interval: A number representing the OSPF Transit Delay for the specified interface.
Authentication Type: The OSPF Authentication Type for the specified interface are: none, simple,
and encrypt.
Metric Cost: The cost of the OSPF interface.
Passive Status: Shows whether the interface is passive or not.
OSPF MTU-ignore: Indicates whether to ignore MTU mismatches in database descriptor packets
sent from neighboring routers.
Flood Blocking: Indicates if flood blocking is enabled or disabled.
The information below will only be displayed if OSPF is enabled.
State: The OSPF Interface States are: down, loopback, waiting, point-to-point, designated router,
and backup designated router.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
683
Need help?
Do you have a question about the QuantaMesh and is the answer not in the manual?