Quanta Computer QuantaMesh User Manual page 431

UANTA COMPUTER INC.
Firmware Rev: Specifies Firmware version of the remote device.
Software Rev: Specifies Software version of the remote device.
Serial Num: Specifies serial number of the remote device.
Mfg Name: Specifies manufacturers name of the remote device.
Model Name: Specifies model name of the remote device.
Asset ID: Specifies asset id of the remote device.
Location Specifies if location TLV is received in LLDP frames on this port.
Subtype: Specifies type of location information.
Info: Specifies the location information as a string for given type of location id.
Extended POE Specifies if remote device is a PoE device.
Device Type: Specifies remote device's PoE device type connected to this port.
Extended POE PSE Specifies if extended PSE TLV is received in LLDP frame on this port.
Available: Specifies the remote ports PSE power value in tenths of watts.
Source: Specifies the remote ports PSE power source.
Priority: Specifies the remote ports PSE power priority.
Extended POE PD Specifies if extended PD TLV is received in LLDP frame on this port.
Required: Specifies the remote port's PD power requirement.
Source: Specifies the remote port's PD power source.
Priority: Specifies the remote port's PD power priority.
5.12.1.13 show lldp dcbx
The user can go to the CLI Privilege Exec to d display the local Data Center Bridging Capability
Exchange (DCBX) control status of an interface on the system, use the show lldp dcbx interface
[<slot/port>] Privilege command.
Syntax
show lldp dcbx interface [<slot/port> [detail]]
Default Setting
None
Command Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 431