Quanta Computer QuantaMesh User Manual page 937

UANTA COMPUTER INC.
8.4.1.7 show ipv6 ospf interface
This command displays the information for the IFO object or virtual interface tables.
Syntax
show ipv6 ospf interface {<slot/port> | loopback <0-7> | tunnel <0-7> | vlan <vlan-id>}
<slot/port> - Interface number.
<0-7> - Loopback/Tunnel Interface ID.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
IPv6 Address: Shows the IPv6 address of the interface.
ifIndex: Shows the interface index number associated with the interface.
OSPF Admin Mode: Shows whether the admin mode is enabled or disabled.
OSPF Area ID: Shows the area ID associated with this interface.
Router Priority: Shows the router priority. The router priority determines which router is the
designated router.
Retransmit Interval: Shows the frequency, in seconds, at which the interface sends LSA.
Hello Interval: Shows the frequency, in seconds, at which the interface sends Hello packets.
Dead Interval: Shows the amount of time, in seconds, the interface waits before assuming a
neighbor is down.
LSA Ack Interval: Shows the amount of time, in seconds, the interface waits before sending
an LSA acknowledgement after receiving an LSA.
Transmit Delay Interval: A number representing the OSPF Transmit Delay for the specified
interface.
Authentication Type: Shows the type of authentication the interface performs on LSAs it
receives.
Metric Cost: Shows the priority of the path. Low costs have a higher priority than high
costs.
OSPF MTU-ignore: Shows whether to ignore MTU mismatches in database descriptor
packets sent from neighboring routers.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands 937