Quanta Computer QuantaMesh User Manual page 968

UANTA COMPUTER INC.
8.4.2.31 enable
This command resets the default administrative mode of OSPF in the router (active).
Syntax
enable
no enable
<no> - This command sets the administrative mode of OSPF in the router to inactive.
Default Setting
Enabled
Command Mode
Router OSPFv3 Config
8.4.2.32 exit-overflow-interval
This command configures the exit overflow interval for OSPF. It describes the number of seconds after
entering Overflow state that a router will wait before attempting to leave the Overflow State. This allows
the router to again originate non-default AS-external-LSAs. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
exit-overflow-interval <0-2147483647>
no exit-overflow-interval
<0-2147483674> - The range of exit overflow interval for OSPF is 0 to 2147483674.
no - This command configures the default exit overflow interval for OSPF.
Default Setting
0
Command Mode
Router OSPFv3 Config
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands 968