Quanta Computer QuantaMesh User Manual page 804

UANTA COMPUTER INC.
6.11.2.12 exit
This command is used to exit bgp configuration mode.
Syntax
exit
Default Setting
None
Command Mode
Router BGP Config Mode
6.11.2.13 timers bgp
This command is used to set the keepalive and holdtime timers. To return the router to default operation,
use the no form of this command.
Syntax
timers bgp <keepalive> <holdtime>
no timers bgp
keepalive: The number of seconds this BGP speaker waits for a keepalive message before deciding
that the connection is down. We recommend you configure the keepalive parameter as 1/3 of the
holdtime parameter.
holdtime: The number of seconds this BGP speaker waits for a keepalive, update, or notification
message before deciding that the connection is down. We recommend you configure the holdtime
parameter as 3 times the keepalive parameter.
Default Setting
The default value of keepalive is 60 seconds.
The default value of holdtime is 180 seconds.
Command Mode
Router BGP Config Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 804