Quanta Computer QuantaMesh User Manual page 94

UANTA COMPUTER INC.
5.2.3.17 switchport mode access
This command configures the an interface to be operated on VLAN access mode. In this mode, only one
VLAN could be assigned to this interface. Use 'switchport access vlan <vlan-id>' to configure the
access VLAN. In VLAN access mode, only the untagged packets are handled.
Syntax
switchport mode access
no switchport mode access
no - This command sets the mode to General.
Default Setting
General Mode
Command Mode
Interface Config
5.2.3.18 switchport access vlan
This command configures the access VLAN ID for an interface if it is operated on access VLAN mode.
Syntax
switchport access vlan <vlan-id>
no switchport access vlan
<vlan-id> - VLAN ID (Range: 1 – 4093).
no - This command sets the access VLAN ID to 1.
Default Setting
1
Command Mode
Interface Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 94