Quanta Computer QuantaMesh User Manual page 211

UANTA COMPUTER INC.
5.3.3.10 telnet sessions
This command regulates new outbound telnet connections. If enabled, new outbound telnet sessions
can be established until it reaches the maximum number of simultaneous outbound telnet sessions
allowed. If disabled, no new outbound telnet session can be established. An established session
remains active until the session is ended or an abnormal network error ends it.
Syntax
telnet sessions
no telnet sessions
no - This command disables new outbound telnet connections. If disabled, no new outbound telnet
connection can be established.
Default Setting
Enabled
Command Mode
Global Config
5.3.3.11 telnet maxsessions
This command specifies the maximum number of simultaneous outbound telnet sessions. A value of 0
indicates that no outbound telnet session can be established.
Syntax
telnet maxsessions <0-5>
no maxsessions
<0-5> - max sessions (Range: 0 - 5).
no - This command sets the maximum value to be 5.
Default Setting
5
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 211