Quanta Computer QuantaMesh User Manual page 427

UANTA COMPUTER INC.
5.12.1.10 show lldp med local-device detail
The user can go to the CLI Privilege Exec to display detailed information about the LLDP-MED data, use
the show lldp med local-device detail <slot/port> Privilege command.
Syntax
show lldp med local-device detail <slot/port>
<slot/port> - Displays a specific interface.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: Identifies the interface.
Network Policies Specifies if network policy TLV is present in the LLDP frames.
Media Policy Application Type: Specifies the application type. Types of application types are
unknown, voicesignaling, guestvoice, guestvoicesignalling, softphonevoice, videoconferencing,
streammingvideo, vidoesignalling. Each application type that is received has the VLAN id,
priority, DSCP, tagged bit status and unknown bit status. A port may receive one or many such
application types. If a network policy TLV has been transmitted only then would this information
be displayed.
Vlan ID: Specifies the VLAN id associated with a particular policy type.
Priority: Specifies the priority associated with a particular policy type.
DSCP: Specifies the DSCP associated with a particular policy type.
Unknown: Specifies the unknown bit associated with a particular policy type.
Tagged: Specifies the tagged bit associated with a particular policy type.
Inventory Specifies if inventory TLV is present in LLDP frames.
Hardware Rev: Specifies hardware version.
Firmware Rev: Specifies Firmware version.
Software Rev: Specifies Software version.
Serial Num: Specifies serial number.
Mfg Name: Specifies manufacturers name.
Model Name: Specifies model name.
Asset ID: Specifies asset id.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 427