Quanta Computer QuantaMesh User Manual page 416

UANTA COMPUTER INC.
5.11.2.10 sntp source-interface
Use this command to specify the physical or logical interface to use as the SNTP client source interface.
If configured, the address of source interface is used for all SNTP communications between the SNTP
server and the SNTP client. Otherwise, there is no change in behavior. If the configured interface is
down, the SNTP client falls back to its default behavior.
Syntax
sntp source-interface {<slot/port> | loopback <loopback-id> | tunnel <tunnel-id> | vlan <vlan-id>}
no sntp source-interface
<slot/port> - Specifies the port to use as the source interface.
<loopback-id> - Specifies the loopback interface to use as the source interface. The range of the
loopback ID is 0 to 7.
<tunnel-id> - Specifies the tunnel interface to use as the source interface. The range of the tunnel
ID is 0 to 7.
<vlan-id> - Specifies the VLAN interface to use as the source interface. The range of the VLAN ID is
1 to 4093.
no - This command will reset the SNTP source interface to its default settings.
Default Setting
None
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 416