Quanta Computer QuantaMesh User Manual page 140

UANTA COMPUTER INC.
When you specify a value for <vlan-id>, the following information appears.
VLAN ID: VLAN ID.
MLD Snooping Admin Mode: Indicates whether MLD Snooping is active on the VLAN.
Fast Leave Mode: Indicates whether MLD Snooping Fast Leave is active on the VLAN.
Group Membership Interval: Shows the amount of time in seconds that a switch will wait for a
report from a particular group on a particular interface, which is participating in the VLAN, before
deleting the interface from the entry. This value may be configured.
Max Response Time: VLANs on which MLD Snooping is enabled.
Multicast Router Expiry Time: Displays the amount of time to wait before removing an interface
that is participating in the VLAN from the list of interfaces with multicast routers attached. The
interface is removed if a query is not received. This value may be configured.
Report Suppression Mode: Admin mode of MLD Snooping Report Suppression Mode.
Vlan Block Mode: VLANs on which IGMP/MLD Snooping is blocked.
5.2.8.2 show ipv6 mld snooping mrouter interface
The user can go to the CLI Privilege Exec to display information about statically configured multicast
router-attached interfaces, use the show ipv6 mld snooping mrouter interface Privilege command.
Syntax
show ipv6 mld snooping mrouter interface {<slot/port> | port-channel <portchannel-id>}
<slot/port> - Interface number.
<portchannel-id> - Port-channel interface number. The range of port-channel ID is 1 to 64.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Interface: Shows the interface on which multicast router information is being displayed.
Multicast Router Attached: Indicates whether multicast router is statically enabled on the interface.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 140