Quanta Computer QuantaMesh User Manual page 882

UANTA COMPUTER INC.
7.6.2.7 ipv6 pim dr-priority
Use this command to set the priority value for which a router is elected as the designated router (DR).
This command can be configured on a single interface or a range of interfaces.
Syntax
ipv6 pim dr-priority <0-4294967294>
no ipv6 pim dr-priority
no - Use this command to disable the interface from being the BSR border.
Default Setting
1
Command Mode
Interface Config
7.6.2.8 ipv6 pim join-prune-interval
This command is used to configure the interface join/prune interval for the PIM-SM router on an interface
or range of interfaces. The join/prune interval is specified in seconds. This parameter can be configured
to a value from 0 to 18000.
Syntax
ipv6 pim join-prune-interval <0-
no ipv6 pim join-prune-interval
no - Use this command to set the join/prune interval to the default value.
Default Setting
60
Command Mode
Interface Config
7.6.2.9 ipv6 pim rp-address
This command is used to define the address of a PIM Rendezvous point (RP) for a specific multicast
group range. The parameter <rp-address> is the IPv6 address of the RP. The parameter
<group-address> is the group address supported by the RP. The parameter <prefix-length> is the group
>
18000
QuantaMesh | IP Multicast Commands
Layer 2/3/4 Managed Switch
882