Quanta Computer QuantaMesh User Manual page 64

UANTA COMPUTER INC.
This command is used to set the speed and duplex mode for all interfaces.
Syntax
speed-duplex all 1000
no speed-duplex all 1000
1000 – 1000 Mbps, only valid for 10G ports.
all - This command represents all interfaces.
no - This command will be back to 10G speed from 1G speed for all 10G ports.
Default Setting
None
Command Mode
Global Config
5.2.1.8 negotiate
This command enables automatic negotiation on a port. The default value is enabled.
The 10-Giga and 40-Giga interfaces do not provide the following command.
i
Syntax
negotiate
no negotiate
no - This command disables automatic negotiation on a port.
Default Setting
Disable
Command Mode
Interface Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 64