Quanta Computer QuantaMesh User Manual page 113

UANTA COMPUTER INC.
20 centiseconds (0.2 seconds)
Command Mode
Global Config
This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service. The time is from 20 to 600 (centiseconds).
This command has an effect only when GVRP and GMRP are enabled.
i
Syntax
garp timer leave < 20-600 >
no garp timer leave
<20-600> - leave time (Range: 20 – 600) in centiseconds.
no - This command sets the GVRP leave time per port to 60 centiseconds (0.6 seconds).
Default Setting
60 centiseconds (0.6 seconds)
Command Mode
Interface Config
This command sets the GVRP leave time for all ports. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service. The time is from 20 to 600 (centiseconds).
This command has an effect only when GVRP and GMRP are enabled.
i
Syntax
garp timer leave all < 20-600 >
no garp timer leave all
<20-600> - leave time (Range: 20 – 600) in centiseconds.
all - All interfaces.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 113