Traceroute - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

5.16.8 traceroute

5.16.8.1 traceroute
Use the traceroute command to discover the routes that packets actually take when traveling to their
destination through the network on a hop-by-hop basis. Traceroute continues to provide a synchronous
response when initiated from the CLI.
Syntax
traceroute <ipaddr|hostname> [initTtl <initTtl>] [maxTtl <maxTtl>]
[interval <interval>] [count <count>]
<ipaddr|hostname> - The IP address or destination host you want to trace.
<initTtl> - The Use initTtl to specify the initial time-to-live (TTL), the maximum number of router hops
between the local and remote system. Range is 1 to 255.
<maxTtl> - Use maxTtle to specify the maximum TTL. Range is 1 to 255.
<interval> - Use interval to specify the time between probes, in seconds. Range is 1 to 60 seconds.
<count> - Use the optional count parameter to specify the number of probes to send for each TTL
value. Range is 1 to 10 probes.
Default Setting
None
Command Mode
Previledge Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 484