Quanta Computer QuantaMesh User Manual page 271

UANTA COMPUTER INC.
5.3.15.2 Configuration Commands
5.3.15.2.1 time-range
Use this command to enable or disable the time range Admin mode.
Syntax
time-range
no time-range
no - This command sets the time-range Admin mode to disalbe.
Default Setting
None
Command Mode
Global Config
5.3.15.2.2 time-range <name>
Use this command to create a time range identified by name, consisting of one absolute time entry
and/or one or more periodic time entries. The name parameter is a case-sensitive, alphanumeric string
from 1 to 31 characters that uniquely identifies the time range. An alpha-numeric string is defined as
consisting of only alphabetic, numeric, dash, underscore, or space characters.
If a time range by this name already exists, this command enters Time-Range config mode to allow
updating the time range entries
Syntax
time-range <name>
no time-range <name>
<name> - The time range name.
no - This command deletes a time-range identified by name.
Default Setting
None
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 271