Quanta Computer QuantaMesh User Manual page 357

UANTA COMPUTER INC.
5.9.2.2 aaa accounting
Use this command in Global config mode to create an accounting method list for either user EXEC
sessions or for user-executed commands. This list is identified by default or a user-specified list_name.
Accounting records, when enabled for a line-mode, can be sent at both the beginning and at the end
(start-stop) or only at the end (stop-only). If none is specified, then accounting is disabled for the
specified list. If tacacs is specified as the accounting method, accounting records are notified to a
TACACS+ server. If radius is the specified accounting method, accounting records are notified to a
RADIUS server.
- A maximum of five Accounting Method lists can be created for each exec and commands
i
type.
- The same list-name can be used for both exec and commands accounting type.
- AAA Accounting for commands with RADIUS as the accounting method is not supported.
Syntax
aaa accounting {exec | commands} {default | <list_name>} { start-stop | stop-only | none} method1
[method2...]
no aaa accounting {exec | commands} {default | <list_name>}
exec - Provide accounting for a user EXEC terminal sessions.
commands - Provide accounting for all user executed commands.
default - The default list of methods for accounting services.
<listname> - Character string used to name the list of accounting methods.
start-stop - Send a start accounting notice at the beginning of a process and a stop accounting
notice at the end of a process.
stop-only - Sends a stop accounting notice at the end of the requested user process.
none - Disables accounting services on this line.
method - Use either TACACS or RADIUS server for accounting purposes.
no – This command deletes the accounting method list.
Default Setting
None
Command Mode
Global Config
5.9.2.3 accounting
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 357