Quanta Computer QuantaMesh User Manual page 1010

UANTA COMPUTER INC.
9.5.2.7 exit
This command returns the switch to Global Configuration mode and enables the VM Tracer session.
Changes to the VM Tracer session that were made in vmtracer mode are stored when the mode is
exited.
Syntax
exit
Default Setting
None
Command Mode
VM Tracer Config
9.5.2.8 vmtracer
The command enables vmtracer mode on the interface configuration mode. Interfaces with vmtracer
mode enabled send discovery packets to the connected host device.
The no vmtracer command disables vmtracer mode on the configuration mode interface.
Syntax
vmtracer
no vmtracer
no - This command disables VM Tracer mode on the configuration mode interface
Default Setting
Disable
Command Mode
Interface Config
QuantaMesh | Data Center Bridging Commands
Layer 2/3/4 Managed Switch
1010