Show Range - Dell Z9500 Command Reference Manual

show range

Display all interfaces configured using the interface range command.
Z9500
Syntax
show range
Command INTERFACE RANGE (config-if-range)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Example
Dell(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
Dell(conf-if-range-so-2/0-1,fa-0/0)#
Related
interface
Commands
show ip interface
show interfaces
interface.
882
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4093 VLANs on E-Series ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
— configures a physical interface on the switch.
— displays Layer 3 information about the interfaces.
— displays information on a specific physical interface or virtual
Interfaces