Class-Map Rename; Match Ethertype; Match Any; Match Class-Map - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

14.3.2 class-map rename

This command changes the name of a DiffServ class. The
name of an existing DiffServ class. The
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the class (The
<class-map-name>
Format
Mode

14.3.3 match ethertype

This command adds to the specified class definition a match condition based on the value
of the ethertype. The
appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe,
rarp or as a custom ethertype value in the range of 0x0600-0xFFFF.
Format
Mode

14.3.4 match any

This command adds to the specified class definition a match condition whereby all packets
are considered to belong to the class.
Format
Mode

14.3.5 match class-map

This command adds to the specified class definition the set of match conditions defined
for another class. The
match conditions are being referenced by the specified class definition.
Format
Mode
The following ruules apply to this command:
• The parameters
• Only one other class may be referenced by a class.
Quality of Service (QoS) Commands
<new-class-map-name>
'default' is reserved and must not be used here).
class-map rename <class-map-name> <new-class-map-
name>
Global Config
value is specified as one of the following keywords:
<ethertype>
match ethertype
0xFFFF>}
Class-Map Config
match any
Class-Map Config
is the name of an existing DiffServ class whose
<refclassname>
match class-map <refclassname>
Class-Map Config
and
<refclassname>
v1.0, February 2007
<class-map-name>
{<keyword> |
can not be the same.
<class-map-name>
is the
parameter is a case-
<0x0600-
custom
14-11