Show Ip Interface - NETGEAR ProSafe GSM7224P User Manual

ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirects................................. Enabled

show ip interface

This command displays all pertinent information about the IP interface.
Format
show ip interface {<unit/slot/port> | vlan <1-4093> | loopback <0-7>}
Modes
• Privileged EXEC
• User EXEC
Term Definition
Routing
Determine the operational status of IPv4 routing Interface. The possible values are Up or
Interface Status
Down.
Primary IP
The primary IP address and subnet masks for the interface. This value appears only if
Address
you configure it.
Secondary IP
One or more secondary IP addresses and subnet masks for the interface. This value
Address
appears only if you configure it.
Helper IP
The helper IP addresses configured by the
Address
Routing Mode
The administrative mode of router interface participation. The possible values are enable
or disable. This value is configurable.
Administrative
The administrative mode of the specified interface. The possible values of this field are
Mode
enable or disable. This value is configurable.
Forward Net
Displays whether forwarding of network-directed broadcasts is enabled or disabled. This
Directed
value is configurable.
Broadcasts
Proxy ARP
Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy
Displays whether Local Proxy ARP is enabled or disabled on the interface.
ARP
Active State
Displays whether the interface is active or inactive. An interface is considered active if its
link is up and it is in forwarding state.
Link Speed Data
An integer representing the physical link data rate of the specified interface. This is
Rate
measured in Megabits per second (Mbps).
MAC Address
The burned in physical address of the specified interface. The format is 6 two-digit
hexadecimal numbers that are separated by colons.
Encapsulation
The encapsulation type for the specified interface. The types are: Ethernet or SNAP.
Type
IP MTU
The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth
Shows the bandwidth of the interface.
ProSafe Managed Switch
ip helper-address (Global Config)
Routing Commands
245
command.