Show Ip Igmp Mrouter Interface; Show Ip Igmp Mrouter Vlan; Show Mac-Address-Table Igmpsnooping - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
When you specify a value for
VLAN Admin
Mode

13.2.2 show ip igmp mrouter interface

This command displays information about statically configured ports.
Format
Mode
Interface
Multicast Router
Attached
VLAN ID

13.2.3 show ip igmp mrouter vlan

This command displays information about statically configured ports.
Format
Mode
Interface
VLAN ID

13.2.4 show mac-address-table igmpsnooping

This command displays the IGMP Snooping entries in the MFDB table.
Format
Mode
MAC Address
13-8
, the following additional information appears:
vlanid
< >
Indicates whether IGMP Snooping is active on the VLAN.
show ip igmp mrouter interface <slot/port>
Privileged EXEC
Shows the port on which multicast router information is
being displayed.
Indicates whether multicast router is statically enabled on the
interface.
Displays the list of VLANs of which the interface is a mem-
ber.
show ip igmp mrouter vlan <slot/port>
Privileged EXEC
Shows the port on which multicast router information is
being displayed.
Displays the list of VLANs of which the interface is a mem-
ber.
show mac-address-table igmpsnooping
Privileged EXEC
A multicast MAC address for which the switch has forward-
ing or filtering information. The format is two-digit hexadec-
imal numbers that are separated by colons, for example
01:23:45:67:89:AB. In an IVL system the MAC address is
v1.0, February 2007
IGMP Snooping Commands