Dot1X Port-Control All; Dot1X Re-Authenticate - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
11.1.8.1 no dot1x port-control
This command sets the authentication mode to be used on the specified port to 'auto'.
Format
Mode

11.1.9 dot1x port-control all

This command sets the authentication mode to be used on all ports. The control mode may
be one of the following modes:
• force-unauthorized — The authenticator PAE unconditionally sets the controlled
port to unauthorized.
• force-authorized — The authenticator PAE unconditionally sets the controlled port to
authorized.
• auto — The authenticator PAE sets the controlled port mode to reflect the outcome of
the authentication exchanges between the supplicant, authenticator and the
authentication server.
Default
Format
Mode
11.1.9.1 no dot1x port-control all
This command sets the authentication mode to be used on all ports to 'auto'.
Format
Mode

11.1.10 dot1x re-authenticate

This command begins the re-authentication sequence on the specified port. This command
is only valid if the control mode for the specified port is 'auto'. If the control mode is not
'auto' an error will be returned.
Format
Mode
Port-Based Access and Authentication Commands
no dot1x port-control
Interface Config
auto
dot1x port-control all {force-unauthorized |
force-authorized | auto}
Global Config
no dot1x port-control all
Global Config
dot1x re-authenticate <slot/port>
Privileged EXEC
v1.0, November 2007
11-5