Time Range Commands For Time-Based Acls - NETGEAR ProSafe GSM7224P User Manual

Term Definition
IP DSCP
The value specified for IP DSCP.
Flow Label
The value specified for IPv6 Flow Label.
Log
Displays when you enable logging for the rule.
Assign Queue
The queue identifier to which packets matching this rule are assigned.
Mirror Interface The unit/slot/port to which packets matching this rule are copied.
Redirect
The unit/slot/port to which packets matching this rule are forwarded.
Interface
Time Range
Displays the name of the time-range if the IPv6 ACL rule has referenced a time range.
Name
Rule Status
Status(Active/Inactive) of the IPv6 ACL rule.

Time Range Commands for Time-Based ACLs

Time-based ACLs allow one or more rules within an ACL to be based on time. Each ACL rule
within an ACL, except for the implicit
operational only during a specific time period. The time range commands allow you to define
specific times of the day and week to implement time-based ACLs. The time range is
identified by a name and can then be referenced by an ACL rule defined with in an ACL.
time-range
Use this command to create a time range identified by
entry and/or one or more periodic time entries. The
alphanumeric string from 1 to 31 characters that uniquely identifies the time range. An
alpha-numeric string is defined as consisting of only alphabetic, numeric, dash, underscore,
or space characters. If a time range by this name already exists, this command enters
Time-Range config mode to allow updating the time range entries
Note: When you successfully execute this command, the CLI mode
changes to Time-Range Config mode.
Format
time-range <name>
Mode
Global Config
ProSafe Managed Switch
rule, can be configured to be active and
deny all
Quality of Service (QoS) Commands
485
, consisting of one absolute time
name
parameter is a case-sensitive,
name