Configuring The Master Switch; General Steps For The Master Switch - Allied Telesis x530DP Series Installation Manual

Configuring the Master Switch

General Steps for
the Master
Switch
This section contains the following procedures for configuring the master
switch of the stack:
"General Steps for the Master Switch," next

"Configuring the Master Switch - Part I" on page 134

"Configuring the Master Switch - Part II" on page 137

"Verifying the Master Switch" on page 139

"What to Do Next" on page 140

Note
The procedures require reseting the switch. Some network traffic will
be lost if the unit is already connected to an active network.
You need to know the following to perform these procedures:
How many member switches will be in the stack?

Which 5Gbps ports will be used as the stack trunk on the master

and member switches? Refer to "Stack Trunks" on page 53.
The procedures should be performed in the order presented here.
The procedure for configuring the master switch to use the 5Gbps ports as
the stacking ports is divided into two parts. Here are the general steps to
Part I:
1. Start a local management session on the switch.
2. Display the hardware status and management software version
number with the SHOW SYSTEM ENVIRONMENT and SHOW
VERSION INSTALLED commands, respectively, in the Privilege Exec
mode.
3. Enable the VCStack feature with the STACK ENABLE command in the
Global Configuration mode. You will probably not have to perform this
step because the default setting for the feature is enabled.
4. Assign the master switch the priority 1 with the STACK PRIORITY
command in the Global Configuration mode. This is to ensure that it is
selected as the master switch during the first power-on of the stack.
5. Remove the stacking function from the default stacking ports 51 and
52 on the master switch with the NO STACKPORT command.
x530DP Series Installation Guide for Virtual Chassis Stacking
133