Show Trapflags - NETGEAR ProSafe GSM7228PS Cli Manual

Term Definition
SNMP Trap The community string of the SNMP trap packet sent to the trap manager. The string is
Name
case sensitive and can be up to 16 alphanumeric characters.
IP Address The IPv4 address to receive SNMP traps from this device.
IPv6 Address The IPv6 address to receive SNMP traps from this device.
SNMP Version SNMPv2
Status The receiver's status (enabled or disabled).
The following shows an example of the CLI command.
(Netgear Switch)#show snmptrap
Community Name
Mytrap 0.0.0.0

show trapflags

This command displays trap conditions. The command's display shows all the enabled OSPFv2
and OSPFv3 trapflags. Configure which traps the switch should generate by enabling or disabling
the trap condition. If a trap condition is enabled and the condition is detected, the SNMP agent on
the switch sends the trap to all enabled trap receivers. You do not have to reset the switch to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Format
show trapflags
Mode Privileged EXEC
Term Definition
Authentication Can be enabled or disabled. The factory default is enabled. Indicates whether
Flag
authentication failure traps will be sent.
Link Up/Down Can be enabled or disabled. The factory default is enabled. Indicates whether link status
Flag
traps will be sent.
Multiple Users Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will
Flag
be sent when the same user ID is logged into the switch more than once at the same time
(either through Telnet or the serial port).
Spanning Tree Can be enabled or disabled. The factory default is enabled. Indicates whether spanning
Flag
tree traps are sent.
ACL Traps May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps
are sent.
Management Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
IpAddress IPv6 Address
2001::1
v1.0, May 2010
Snmp Version
SNMPv2 Enable show trapflags
Mode
8-51