Show Trapflags - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

10.2.3 show trapflags

This command displays trap conditions. Configure which traps the switch should generate
by enabling or disabling the trap condition. If a trap condition is enabled and the condition
is detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You
do not have to reset the switch to implement the changes. Cold and warm start traps are
always generated and cannot be disabled.
Format
Mode
Authentication
Flag
Link Up/Down
Flag
Multiple Users
Flag
Spanning Tree
Flag
Broadcast Storm
Flag
DVMRP Traps
OSPF Traps
PIM Traps
10-12
show trapflags
Privileged EXEC
Can be enabled or disabled. The factory default is enabled.
Indicates whether authentication failure traps will be sent.
Can be enabled or disabled. The factory default is enabled.
Indicates whether link status traps will be sent.
Can be enabled or disabled. The factory default is enabled.
Indicates whether a trap will be sent when the same user ID is
logged into the switch more than once at the same time
(either via telnet or serial port).
Can be enabled or disabled. The factory default is enabled.
Indicates whether spanning tree traps will be sent.
Can be enabled or disabled. The factory default is enabled.
Indicates whether broadcast storm traps will be sent.
Can be enabled or disabled. The factory default is disabled.
Indicates whether DVMRP traps will be sent.
Can be enabled or disabled. The factory default is disabled.
Indicates whether OSPF traps will be sent.
Can be enabled or disabled. The factory default is disabled.
Indicates whether PIM traps are sent.
v1.0, December 2005
SNMP Commands