Port And System Setup Commands; Port Configuration Commands; Interface - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

This section describes general port and system setup commands available in the 7200R
Series Managed Switch CLI.
This section contains the following topics:
• Section 4.1 "Port Configuration Commands" on page 4-1
• Section 4.2 "Pre-login Banner and System Prompt Commands" on page 4-10
• Section 4.3 "Simple Network Time Protocol (SNTP) Commands" on page 4-11
• Section 4.4 "MAC Address and MAC Database Commands" on page 4-17
• Section 4.5 "DNS Client Commands" on page 4-24
The commands in this section are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
• Copy commands transfer or save configuration and informational files to and from the
switch.

4.1 Port Configuration Commands

This section describes the commands you use to view and configure port settings.

4.1.1 interface

This command gives you access to the Interface Config mode, which allows you to enable
or modify the operation of an interface.
Format
Mode

Port and System Setup Commands

Port and System Setup Commands
interface <slot/port>
Global Config
v1.0, November 2007
Chapter 4
4-1