•
"LLDP-MED Commands" on page 3-168
•
"Denial of Service Commands" on page 3-179
•
"MAC Database Commands" on page 3-191
•
"ISDP Commands" on page 3-193
Warning: The commands in this chapter are in one of three functional groups:
•
Show commands display switch settings, statistics, and other information.
•
Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the
configuration setting.
•
Clear commands clear some or all of the settings to factory defaults.
Port Configuration Commands
This section describes the commands you use to view and configure port settings.
interface
This command gives you access to the Interface Config mode, which allows you to enable or
modify the operation of an interface (port).
Format
interface <unit/slot/port>
Mode
Global Config
interface range
This command gives you access to a range of port interfaces, allowing the same port configuration
to be applied to a set of ports.
Format
interface range <unit/slot/port>-<unit/slot/port>
Mode
Global Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-2