Diffserv Service Commands; Service-Policy - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

13.5 DiffServ Service Commands

Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which
you specified by using the policy commands, to an interface in the incoming direction
The service commands attach a defined policy to a directional interface. You can assign
only one policy at any one time to an interface in the inbound direction. DiffServ is not
used in the outbound direction.
This set of commands consists of service addition/removal.
The CLI command root is

13.5.1 service-policy

This command attaches a policy to an interface in the inbound direction. The
<policyname>
causes a service to create a reference to the policy.
Note: This command effectively enables DiffServ on an interface in the inbound
Note: This command fails if any attributes within the policy definition exceed the
Format
Modes
Note: You can only attach a single policy to a particular interface at any time.
Quality of Service (QoS) Commands
service-policy
parameter is the name of an existing DiffServ policy. This command
direction. There is no separate interface administrative 'mode' command
for DiffServ.
capabilities of the interface. Once a policy is successfully attached to an
interface, any attempt to change the policy definition, that would result in a
violation of the interface capabilities, causes the policy change attempt to
fail.
service-policy in <policymapname>
Global Config
Interface Config
v1.0, March 2006
.
13-21