Policy-Map Rename; Diffserv Service Commands; Section 13.5 "Diffserv Service Commands - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Format
Mode
13.4.9.1 no policy-map
This command eliminates an existing DiffServ policy. The
name of an existing DiffServ policy. This command may be issued at any time. If the
policy is currently referenced by one or more interface service attachments, this delete
attempt fails.
Format
Mode

13.4.10 policy-map rename

This command changes the name of a DiffServ policy. The
an existing DiffServ class. The
alphanumeric string from 1 to 31 characters uniquely identifying the policy.
Format
Mode

13.5 DiffServ Service Commands

Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which
you specified by using the policy commands, to an interface in the incoming direction
The service commands attach a defined policy to a directional interface. You can assign
only one policy at any one time to an interface in the inbound direction. DiffServ is not
used in the outbound direction.
This set of commands consists of service addition/removal.
The CLI command root is
13-20
policy-map <policyname> in
Global Config
no policy-map <policyname>
Global Config
<newpolicyname>
policy-map rename <policyname> <newpolicyname>
Global Config
.
service-policy
v1.0, December 2005
<policyname>
<policyname> i
parameter is a case-sensitive
Quality of Service (QoS) Commands
parameter is the
s the name of