Mpls Create-Dynamic-Interfaces - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

mpls create-dynamic-interfaces

mpls create-dynamic-interfaces
Syntax
{ ip | ipv6 } on-major-interfaces [ for-vpn-traffic ] [ profile profileName ]
no mpls create-dynamic-interfaces
{ ip | ipv6 } on-major-interfaces [ for-vpn-traffic ]
Command introduced in JUNOSe Release 7.1.0.
Release Information
Specifies whether dynamic IP interfaces are automatically created on top of all MPLS
Description
major interfaces, and if so, which profile is used to create them. By default, one IPv4
dynamic interface without a profile is created and used for both VPN and non-VPN
traffic. If IPv6 is enabled on the virtual router, then by default, one IPv6 dynamic
interface without a profile is created and used for both VPN and non-VPN traffic. The
no version restores the default behavior.
Options
Global Configuration
Mode
ip Specifies that the created dynamic interfaces are IPv4
ipv6 Specifies that the created dynamic interfaces are IPv6
for-vpn-traffic Specifies that the created dynamic interface is used for BGP/MPLS
VPN traffic; VPN traffic uses the same IP interface as non-VPN traffic if separate
IP interfaces are not created for the VPN traffic
profileName Name of a profile that sets the values that configure the IP interface;
if you do not specify a profile, the interface attributes are set to their default
values
Chapter 13: M Commands
mpls create-dynamic-interfaces
1325