Cylinder Surface Transformation In Shopmill - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring cycles
22.9 Milling with ShopMill
MD52281 $MCS_TOOL_MCODE_FUNC_ON[ ]
= -1
[0]
[1]
[2]
[3]
MD52282 $MCS_TOOL_MCODE_FUNC_OFF[ ]
= -1
[0]
[1]
[2]
[3]
Channel-specific cycle setting data
SD55212 $SCS_FUNCTION_MASK_TECH_SET
= 6
Bit 0
Bit 1
Bit 2
22.9.2

Cylinder surface transformation in ShopMill

Precondition
● There must be at least one rotary axis at the machine.
● The milling tool must be radially oriented to the cylinder to be machined.
566
M function is not output.
If both M commands of a function "= -1", the corresponding field is not displayed on the
interface.
M code for tool-specific function 1 ON
M code for tool-specific function 2 ON
M code for tool-specific function 3 ON
M code for tool-specific function 4 ON
M function is output.
If both M commands of a function "= -1", the corresponding field is displayed on the
interface.
M code for tool-specific function 1 OFF
M code for tool-specific function 2 OFF
M code for tool-specific function 3 OFF
M code for tool-specific function 4 OFF
Tool preselection active.
The next tool is prepared directly after a tool change.
Note: For a revolver, the setting data must be set to "0".
Automatic calculation of the thread depth for metric threads.
Take the thread diameter and thread depth from the table.
Software options
You require the following software option in order to use this function:
"Transmit and peripheral surface transformation".
M code for tool-specific function ON
M code for tool-specific function OFF
Cross-technology function screen
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)