Scenario
: Start the command shell using the VNC Viewer on the programming device
II
Procedure:
1. Start the VNC Viewer and connect to the NCU using the IP address (or where relevant,
2. Log on under the "manufact" user name with the password "SUNRISE".
3. To restore the data, enter the corresponding commands as described under steps 3 to 5
NCU operating system (IM7)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
using the host name)
in scenario
.
I
Service and diagnostics
3.4 Backing up data via the service shell
79