Configuring The User Interface - Siemens SINUMERIK 840D sl Commissioning Manual

Setting the manual tool function
MD22562 $MC_TOOL_CHANGE_ERROR_MODE
Bit 1 = 1
Bit 2 = 1
Note
If, in machine data MD22562 $MC_TOOL_CHANGE_ERROR_MODE bit 2 = 1, then you
have the option, using a correction selection (D No.) in the program, to stop the machine
until the PLC signals that the tool change has been completed. To do this, in machine data
MD20270 $MC_CUTTING_EDGE_DEFAULT must be set to = 0.
12.2

Configuring the user interface

Configurable settings
The following settings can be configured:
● General settings
● Configure the tool lists
● Configure the list parameters
● Configure tool types
● Configure the "Additional Data" window
● Configure the "New Tool - Favorites" window
● Configuring the "New Tool" window
● Configuring default values for new tools
● Configuring the "Details" window
● Assigning names for magazines and magazine locations
● Assigning a name for magazine location types
● Assign magazines to channels
● Coolant and tool-specific functions
● Reason for the tool change when reactivating
● Configuring the code carrier connection
The following sections explain how you configure these adaptations.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Manual tools can be loaded.
Active D No. > 0 and active T No. = 0 generate an alarm message.
Active D No. > 0 and active D No. = 0 generate an alarm message.
Tool management
12.2 Configuring the user interface
Response when errors occur at tool
change.
131