Configuring The Channel Operational Message - Siemens SINUMERIK 840D sl Commissioning Manual

Customizing the "Machine" operating area

8.4 Configuring the channel operational message

8.4 Configuring the channel operational message
Overview
The channel operational messages are displayed in the third line of the header in the
"Machine" operating area. There are two types of channel operational messages:
1. Channel operational messages that require an operator action to continue a program, e.g.
feed enable missing, M01 active.
The channel operational messages are identified by exclamation marks.
2. Channel operational messages that do not require an operator action to continue a
program. A stop condition is active for a length of time (>1 s) and is interrupted by the
program processing, e.g. dwell time active, waiting for tool change.
The channel operational message is identified by a clock icon and disappears after a
certain time.
File
The settings for this are specified in the "slmahdconfig.ini" file.
Configuring the channel operational message
Section
CondStopIcons
CondDelayTime
Procedure
1. Copy the "slmahdconfig.ini" file from the /siemens/sinumerik/hmi/template/cfg directory.
2. Place the file in the following directory: /oem/sinumerik/hmi/cfg or /user/sinumerik/hmi/cfg.
3. Open the file and make the required settings.
94
Meaning
Specification of an icon that is to be displayed with a certain channel operational
message.
If no icon is specified for a certain channel operational message, then the icon
specified for "DefaultIcon" is displayed.
Specification of how long (in milliseconds) a certain message must be present
before it is displayed.
If no time is specified for a certain channel operational message, then the
•
time specified at "CondDelayTime" is used.
If the channel operational message is to be displayed immediately, "0" must
•
be specified as time.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)