Siemens SINUMERIK 840D sl Commissioning Manual page 143

Entries
FiltersCombinedWithOr
MagazineMoveMessage
ToolLoadErrorMessage
The following settings refer to markings in the lists:
True - marking is displayed.
False - marking is not displayed (default setting).
If several markings apply to one location, the most important information is displayed. For
instance, if a tool is locked, and at the same time, the "Tool position" and the "Reference
direction holder angle" for this tool do not match, then a red cross is displayed for locked.
The yellow triangle for the conflict cannot be seen.
Entries
ShowSymbolActivePlace
ShowSymbolActiveMultiToolPlace
ShowSymbolLoadPlace
ShowSymbolChangeInSpindlePlace
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
12.2 Configuring the user interface
Meaning
Defines the filter criteria, which are linked in the filter
window using a logical OR. The default setting for all the
filter criteria is a logical AND. The possible entries are:
"StandBy" - for tools that are ready for use
•
"Active" - for tools with active identifier
•
"Locked" - for locked tools
•
"Prewarn" - for the prewarning limit
•
"RemainingPieces" - for the remaining unit quantity
•
"RemainingTime" - for the remaining tool time
•
"MarkedToUnload" - for the unload identifier
•
"MarkedToLoad" - for the load identifier
•
True - "Magazine movement running" or "Magazine
movement ended" message is displayed.
False - default setting, message is not displayed.
Refers to the output of the fault message due to a
negative PLC.
True - default setting, the fault message is displayed.
False - the fault message is not displayed.
Meaning
Marking of the magazine location at the machining position.
True - default setting applies for the "Revolver" magazine
type.
False - setting for all other magazine types.
Marking of the multitool location at the machining position.
Is only displayed when the multitool is located in the spindle
or the toolholder.
True - default setting.
Selection of the magazine location at the loading position.
True - default setting applies for all magazine types (except
Revolver is true).
False - setting for the "Revolver" magazine type.
Marking of the magazine location at the change position.
True - default setting applies for all magazine types (except
Revolver is true).
False - setting for the "Revolver" magazine type.
Tool management
137