Turning With Shopturn - Siemens SINUMERIK 840D sl Commissioning Manual

ENDIF
;
IF _ACT==2
G0 A=DC(90)
ENDIF
;
IF _ACT==3
G0 A=DC(180)
ENDIF
;
IF _ACT==4
G0 A=DC(270)
ENDIF
;
;––––––––––––––––––––––––––––––––––––
_NV=_NPV+_ACT ;
N10 G[8]=_NV ;
RET
22.10

Turning with ShopTurn

General
All of the MD and SD settings of the standard cycles can be found in Chapter "Configuring
cycles (Page 451)", and are also applicable for milling under ShopMill and turning under
ShopTurn.
22.10.1 Setting-up ShopTurn cycles for turning
MD52210 $MCS_FUNCTION_MASK_DISP
Bit 0 = 1
Bit 1 = 1
Bit 4 = 1
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Calculate current zero offset
There must not be a calculation here
Dimension system for programs always in the basic system (default setting)
Face view when turning (default setting)
Display follow-on tool in the T,F,S window
Configuring cycles
22.10 Turning with ShopTurn
Function mask display
569