Siemens SINUMERIK 840D sl Commissioning Manual page 551

SD54674 $SNS_MEA_CM_SPIND_ROT_DIR[0]
= 4
Note
If the spindle is already rotating when the measuring cycle is called, this direction of rotation
remains independent of the setting of this data.
SD54675 $SNS_MEA_CM_FEEDFACTOR_1[0]
= 10
= 0
>= 1
SD54676 $SNS_MEA_CM_FEEDFACTOR_2[0]
= 0
>= 1
Note
Feedrate factor 2 should be less than feedrate factor 1.
SD54677 $SNS_MEA_CM_MEASURING_ACCURACY[0]
= 0.005
SD54692 $SNS_MEA_T_CIRCULAR_ARC_DIST
= 0.25
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Spindle rotation the same as M4 (default value)
Default value
Only single probing with the feedrate calculated by the cycle. However, as a minimum, the
value from SD54673[0] $SNS_MEA_CM_MIN_FEEDRATE.
First probing with feedrate. However, as a minimum with the value from
SD54673[0] $SNS_MEA_CM_MIN_FEEDRATE)
SD54675[0] $SNS_MEA_CM_FEEDFACTOR_1
Second probing with the feedrate calculated by the measuring cycle. This is only effective
for SD54673[0] $SNS_MEA_CM_FEEDFACTOR_1 > 0, default value
Second probing with the feedrate from SD54673[0] $SNS_MEA_CM_MIN_FEEDRATE
feedrate factor 2.
Third probing with the calculated feedrate.
Default value
Default value
*)
Configuring cycles
22.8 Measuring cycles and functions
Spindle direction of rotation to
measure tools.
Feedrate factor 1
Feedrate factor 2
Specified measuring accuracy.
The value of this parameter always
refers to the last probing of the tool
at the probe!
Arc distance for the single cutting edge
measurement of the radius.
545