Siemens SINUMERIK 840D sl Commissioning Manual page 183

Tool change reasons
You can adapt or expand the tool change reasons as required. The operating software
provides the following pre-defined texts for the configuration:
Text identifier
TM_DGL_DESIRED_PIECES_ELAPSED
TM_DGL_TOOL_BREAKAGE
TM_DGL_CUTTING_EDGE_DAMAGE
TM_DGL_PREMATURE_WEAR
TM_DGL_TYPE_REEQUIPPING
TM_DGL_TOOL_TRIAL
TM_DGL_PREVENTIVE_CHANGE
<TOOLCHANGEREASON> tag
You configure the function in the <TOOLCHANGEREASON> tag:
Parameter
Enabled
OnlyOneReasonAllowed
UseCapLocalParameter
REASONXXX
Text
Parameter
BitMask
Local variable of the SICap service
The identifier of the local variables is called "/Hmi/ToolEdgeReplacementReason". The
variable is the string type.
The table below lists the most important arguments and their significance:
Argument
datetime
containerNo
toaNo
toolNo
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Text
Unit quantity setpoint (desired pieces) elapsed
Tool breakage
Cutting edge damage
Premature wear
Type reequipping
Tool trial
Preventive change
Designation
true - "Reason for tool change" selection window is displayed when
reactivating.
false - default value, selection window is not displayed.
It is only permissible to select one tool change reason.
The reason for the tool change is entered into a local variable of the
SlCap service.
XXX stands for an internal number. The numbers for the tool change
reason must be clear and unique.
Text identifier of the tool change reason.
Parameter identifier of the parameter in which it is entered whether the
tool change reason was selected.
Bit mask to enter the reason for the change in the local variable of the
SlCap service. The bit mask is entered as integer value. Bit 0 → 1,
bit 1 → 2, bit 2 → 4
Meaning
Data and time of the event
Number of the management area
Number of the To area
Tool number
Tool management
12.2 Configuring the user interface
177