Siemens SINUMERIK 840D sl Commissioning Manual page 557

= 3
= 4
SD55623 $SCS_MEA_EMPIRIC_VALUE[n]
= 0
SD55618 $SCS_MEA_SIM_ENABLE
= 0
= 1
Configuring input screens for measuring cycles in the program editor
Using the following setting data, you configure the display screen and the correction options
when making measurements in the AUTOMATIC mode:
● SD54760 $SNS_MEA_FUNCTION_MASK_PIECE measure workpiece: Measuring cycles
● SD54762 $SNS_MEA_FUNCTION_MASK_TOOL measure tool: Measuring cycles in the
Note
If you have created the prerequisites described in this chapter and you have set and
checked the machine/setting data, you can perform measurements at the machine with a
workpiece or tool probe in the AUTOMATIC mode!
If you wish to set-up workpiece measurement on a lathe, then additional settings are
required. Refer to the Chapter "Measuring workpieces in turning (Page 562)" for the settings.
If you wish to set-up tool measurement using a tool probe, then you must also make
additional settings. Please refer to the Chapters "Measuring tools for turning (Page 563)" or
"Tool measurement in milling (Page 555)" for the settings.
A description is provided in the following chapters as to which settings you can make in order
to adapt measuring to the specific requirements of your particular machine.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
The measuring cycle stops an internal machine data, the measuring result is statically
displayed on the screen!
Continue with NC start, the measuring result screen is deselected.
The measuring result is only displayed on the screen for cycle alarms 61303, 61304, 61305,
61306.
Continue with NC start, the measuring result display on the screen is deselected.
Default value
When calling measuring cycles in conjunction with SINUMERIK Operate, ShopMill or
ShopTurn simulation, the measuring cycles are skipped, default value.
Default setting:
When calling measuring cycles in conjunction with SINUMERIK Operate, ShopMill or
ShopTurn simulation, the measuring cycles are run through. However, no corrections are
performed and there is no logging. There is no screen display of the measuring result.
in the milling area, see Chapter "Workpiece measurement, general (Page 552)"
milling area, see Chapter "Tool measurement in milling (Page 555)"
Configuring cycles
22.8 Measuring cycles and functions
Empirical values
Measuring cycle simulation
551