Siemens SINUMERIK 840D sl Commissioning Manual page 462

Configuring cycles
22.2 Technology cycles for drilling
Bit 6
Bit 7
Tapping (CYCLE84 and CYCLE840)
If the technology screens are hidden using the channel-specific configuration machine data
MD52216 $MCS_FUNCTION_MASK_DRILL, then the settings in the following channel-
specific cycle setting data are effective:
SD55481 $SCS_DRILL_TAPPING_SET_GG12[0]
= 0
= 1
= 2
= 3
SD55482 $SCS_DRILL_TAPPING_SET_GG21[0]
= 0
= 1
= 2
= 3
SD55483 $SCS_DRILL_TAPPING_SET_GG24[0]
= 0
= 1
= 2
For settings under ShopTurn, please refer to Chapter Drilling centered under ShopTurn
(Page 573)
Tapping (CYCLE84)
SD55484 $SCS_DRILL_TAPPING_SET_MC[0]
= 0
= 1
456
Boring CYCLE86: Adapt the spindle position to the tool orientation
Tool orientation can be realized using TOOLCARR or TRAORI before the cycle is called.
= 1 Bits 1 and 2 are no longer effective.
Boring CYCLE86: Adapt the direction of retraction travel in the plane to the active
mirroring
= 0 Retraction in the plane is realized as programmed.
= 1 When mirroring is active, the direction when retracting in the plane is adapted in the cycle
to the active mirroring.
Exact stop response as before the cycle call (default value).
G601
G602
G603
Acceleration behavior as before the cycle call (default value).
SOFT
BRISK
DRIVE
Precontrol, the same as before the cycle call (default value).
FFWON
FFWOF
For MCALL, reactivate spindle operation (default value).
For MCALL, remain in position controlled spindle operation.
Exact stop response
Acceleration behavior
Feedforward control
Spindle operation for MCALL
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)